How to Use the Eye Recovery Pro MaskUpdated a month ago

LIGHT SENSITIVITY TEST

We highly recommend users perform a light sensitivity patch test before commencing treatment.

1. Place the device on the inner forearm.

2. Turn on the device to start a treatment session.

3. Wait till the treatment session is complete. This will take 3 minutes.

4. If your skin feels hot or uncomfortable at any time during the treatment, stop treatment immediately and remove from skin. You may be sensitive to light.

5. The device will automatically turn off once the treatment is done. Remove the device and wait for at least 24 hours before your next treatment.

6. After treatment, if your skin appears red for longer than 2 hours and/or feels hot, itchy, or irritated, you are likely sensitive to light and should not use the device. In case of light sensitivity, discontinue use and contact Solawave customer support. 

HOW TO USE THE DEVICE

1. Prior to using the device:

   1. make sure to conduct a light sensitivity patch test as described in the previous section.

   2. make sure the device is fully charged and that the protective eyewear is inserted in the mask. The protective eyewear is required in order to use the device–please ensure they are properly installed each time you use the device.

2. Start with clean, dry skin free of any makeup and sunscreen. 

3. Make sure the device is unplugged from the charger. 

4. Place the mask over your eye area and fasten the strap for a comfortable fit.

5. Turn on the device by pressing the ON/OFF button on the right side of the mask for 2 seconds. You will see the lights turn on. Note: Device should only be turned on when secured on your face.

6. Enjoy the treatment.

   1. The device switches off automatically after a 3-minute treatment session.

   2. You may stop the treatment at any time by pressing the ON/OFF button for 2 seconds.

7. Remove the mask from your face.

8. After completing your treatment, gently clean the device using a water- or alcohol-based wipe. Ensure the device is not connected to the power supply when cleaning. Do not submerge the device in water or apply water directly to the device.

9. Repeat these steps based upon the treatment protocol described in the next section.

TREATMENT PROTOCOL

Use the device 3 minutes per day, 3-5 days per week for a minimum of 4 weeks. Do not overuse the device beyond the recommended usage of once per day, for 3-5 days per week. 

Always be mindful of how your skin reacts to beauty devices, and stop usage if redness or irritation occur.

HOW TO ADJUST THE STRAPS

1. Place the mask flat on a table with the LED lights facing upward.

2. Locate the adjustment sliders on the inside of the mask, where the straps feed through the slots.

3. Shorten or lengthen each strap by sliding it through the slot until it matches your head size.

4. Pick up the mask and hold it gently against your face, with the LED side touching your skin.

5. Wrap the straps around the crown of your head and fasten the velcro ends behind your head.

6. Check that the mask feels secure without pulling or discomfort.

7. Look at the straps to make sure they lie flat and aren’t twisted for maximum comfort.

To remove: Simply peel apart the velcro connections behind your head and gently lift the mask away.

*If you purchased prior to March 2026, please download the User Manual here.